Jelrus Infinity M-30 - Program and Operate: Three Stage

OPERATION
PROGRAM AND OPERATE - THREE STAGE PROGRAM (Figure1)
11
1FollowTwoStageProgram,Steps1-4
2PressENTER/REVIEWSTAGE2lightturnsoff,STAGE3andHEATRATElightsturnonMain 
DisplayshowsfourheatratechoicesChooseone:
 ASelectheatratebetween1°F-30°F/min(1°C-17°C/min)using 
BSelect"FULL"toprogrammaximumheatrate
 CSelect"COOL"toprogramthefurnacetocooltoaselectedtemperature
 DSelect"NO"toturnofSTAGE3and4ThiswillresultinaTwoStageProgram
NOTE: The HEAT RATE cannot be programmed to "COOL" in STAGE 1 - only in STAGE
2, 3 or 4.
3PressENTER/REVIEWHEATRATElightturnsoffandTEMPlightturnsonEnterforthe
temperaturerequired:heatingtemperatureuptoamaximumof2012°F(1100°C)orcooling 
temperaturedowntoaminimumof100°F(38°C)
4PressENTER/REVIEWTEMPlightturnsoffandHOLDTIMElightturnsonEntertoprogramthe
timeneededtoholdattheabovetemperature(0-4hrs)
5Forthreestages,thefurnacemustbeprogrammednottouseSTAGE4Followthesesteps:
 AAftercompletingStep4,pressENTER/REVIEWSTAGE3lightturnsoff,STAGE4andHEAT 

RATElightsturnon
 BPressMainDisplayshows“5,4,3,2,1,COOL,NO”Select“NO”toprogramthe
furnacenottouseSTAGE4
6Allnecessaryinformationforthisprogramisnowentered
7Toruntheprogramimmediately,pressSTART/STOP
8Todelaythestartoftheprogramtobereadytocastatthepre-settime(seeOneStageProgram,
Step3),pressNIGHTTIME(DELAYSTART)
NOTE: If NIGHT TIME (DELAY START) is pressed while a program is running, the time
remaining for completion of the program will appear on the Main Display for 5 seconds.







