Jelrus Infinity M-30 - Replace Triac Component

FIELD SERVICE
REPLACEMENT OF THE TRIAC (PN 15475)
26
1 Removethelowerrearpanel(Figure2)
2 Noteandrecordthecolorandlocationofeachofthethreewiresonthetriacterminals
 (Figure5A)RemoveeachofthethreewiresbypullingstraightupontheconnectorDONOT
 PULLONTHEWIRES
3 RemovethetwonutsandscrewsthatholdtriacinplaceLifttriacofftherearpanel(Figure5A)
4 ThereisaninsulatingpadlocatedbetweentriacandpanelIfitdidnotcomeoffwiththetriac,
 removeitfromtherearpanelDonotreuseWipetherearpaneltoremoveanygrease-like
 materials
5 PutthenewinsulatingpadandthenthenewtriacinplaceontherearpanelLocatethetriac
 sothatthecenterterminalwillfacedownwardwhentherearpanelisinplace
6 Replacethethreewiresonthetriacterminals(Figure5A)observingthefollowingcolorcoding:
 Yellowwiretoupperrightterminal
 Bluewiretocenter(lower)terminal
 Orangewiretoupperleftterminal
7 Replacethelowerrearpanel(Figure2)