Jelrus Infinity M-30 - Edit.While.A.Program.Is.Running

OPERATION
EDIT WHILE A PROGRAM IS RUNNING (Figure1)
14
1Toidentifywhichprogramisrunning,pressPROGRAMNUMBER
NOTE: The program number cannot be changed using while the program is running.
2Todeterminethetimeremainingforthecompletionoftheprogram,pressNIGHTTIME(DELAYSTART)
ThetimeremainingappearsontheMainDisplayfor5seconds
3Anyindividualparametercanbeincreasedordecreasedduringtheactualrunningofall30
programs
NOTE: HEAT RATE cannot be changed to "NO" in the stage currently running or in the
stages already completed.
4Tochangeaparameterwhileaprogramisrunning,pressENTER/REVIEWtoadvancetothedesired
STAGEandparameter(ieHEATRATE,TEMPorHOLDTIME)Initially,STAGE1willappear  
Anyparametercanbeincreasedordecreasedbypressing or 
5AnyprogramcanbestoppedorstartedbypressingtheSTART/STOPbutton
6IfaprogramiseditedwhilerunningandtheHEATRATEinSTAGE2,3or4issetto"COOL"butthe
correspondingTEMPprogrammedisenteredtoheattoahighertemperaturethanthepreviousstage,
theInfinitywilltrytoheatwitha0°F/Min(0°C/Min)HEATRATEInthiscase,whenNIGHT 
TIME(DELAYSTART)ispressed,99:99(Hr:Min)flashesontheMainDisplay,indicatingthatthe
programcannotbecompleted



