Jelrus Infinity M-30 - Page 9

INSTALLATION
8
Whenaprogramiscompleted,20"beeps"soundevery15minutestoremindtheoperatorthatthe
materialisreadytocast
1BesuretheInfinityisintheidlemode-noprogramusrunning
2Pressand(whileholding)pressPROGRAMNUMBERtodisplaythestatusofthe"beep"
"ON"indicatesthebeepisactive"OFF"indicatesthebeepisinactive
3Useeitherofthe toturnthe"beeps"onoroff
4Toreturntotheidlemode,wait7secondsorpressSTOP/STARTtwice(IfSTOP/START
ispressedonce,cyclestarts)
TO TURN THE “BEEP” ON AND OFF (Figure1)


