Basic service 31
B
ASIC
SERVICE
This chapter describes the maintenance procedures that you can perform
yourself:
• “Cleaning”, below
• “Fuse replacement” on page 31
• “Filter replacement” on page 34
• “Firmware updates” on page 34
CLEANING
Regular cleaning of the exterior elements, as well as the fans and air
vents, is vital to maintaining the operational quality of the Glaciator X-
Stream.
Important! Excessive dust, smoke fluid, and particulate buildup degrades
performance and causes overheating and damage to the
device that is not covered by the warranty.
Cleaning the fan and air vents
To maintain adequate cooling, dust must be cleaned from the fan and air
vents periodically. Remove dust from the fan and air vents with a soft
brush, cotton swab, vacuum, or compressed air.
FUSE REPLACEMENT
The Glaciator X-Stream uses six fuses. An indication that one of the fuses
may have blown is that when power is applied the condenser fan does not
operate or the compressor will not start.
If the fuse blows repeatedly, there is a fault with the unit that requires
service by a Martin technician.
Never bypass the fuse or replace it with one of another size or rating.
Installing any other fuse may damage the device!
To Next Page
Loading...
