34 Glaciator X-Stream user manual
FILTER REPLACEMENT
The Heavy Fog Glaciator uses a washable synthetic fiber filter in the air
intake for the condenser unit (located at the top of the machine). This can
be removed for cleaning by removing the ventilation grill above it (four M5
screws).
Use the following guidelines for when to check the filter. Under
• Normal conditions (clean and dry environment), inspect and
clean/replace the filter every 250 hours
• Severe conditions (dirty and/or damp environment), inspect and
clean/replace the filter every 150 hours
FIRMWARE UPDATES
The factory installed firmware version is indicated on the serial number
label.
Firmware is installed using a Martin AVR Uploader and a PC. To install the
firmware update:
1 Prepare the AVR Uploader as described in its user manual.
2 Disconnect the fixture from mains power.
To Next Page
Loading...
