8 Glaciator X-Stream user manual
I
NSTALLATION
The chapter describes:
• “Fixture location”, below
• “AC power”, below
• “Installing a remote fluid system” on page 9
• “Remote control configurations” on page 11
FIXTURE LOCATION
1 Place the machine on a level surface and ensure that it is stable.
2 Ensure that there is a minimum clearance of 0.5 meters (20 inches)
around fans and air vents. Otherwise the device may overheat and the
thermostatic switch will temporarily cut the power.
3 Read “Safety information” on page 5 and ensure that the fixture is located
so that the safety requirements are met.
AC POWER
The Glaciator X-Stream is available in two models:
• 208V / 60Hz version (200-220V supplies)
• 230 V / 50Hz version (220-245V supplies)
Warning! For protection from dangerous electric shock, the device must
be grounded (earthed). The AC mains supply shall have
overload and ground-fault protection.
Verify that the feed cables are undamaged and rated for the
current requirements of all connected devices before use.
Consult a qualified electrician if you have any doubts about
proper installation.
The:
• 230 V / 50 Hz version of the Glaciator X-Stream is fitted with an IEC 32A
single phase connector.
To Next Page
Loading...
