Ethernet TCP/IP-Adresse
Example: EIP192.168.2.100 (Default value)
Ethernet NetMask
Example: ENM255.255.255.0 (Default value)
Ethernet Gateway
Example: EGW192.168.1.10 (Default value)
Ethernet Port Nummer
Example: EPRT10001 (Default value)
Abfrage der Ethernet MAC Adresse
Restore the factory settings for the Ethernet TCP/IP
IP Adress to 192.168.2.100
NetMask to 255.255.255.0
Gateway to 192.168.1.10
Port Number to 10001
10.6.19 Bus Module Information
Baud rate of the optional CANopen interface
Set cycle time [microseconds] in Cyclic Synchronous Position
Mode (DS402). Used RMR for interpolation. Only multiple of
100 micro seconds possible
Versions number of the installed bus module firmware
IP address queries EtherNet/IP modules (from version V4.00)
MAC address query of PROFINET / Powerlink / EtherNet/IP
bus module
Re-adjust Bit „P402 Set Point Acknowledge“ to behavior.
equal or smaller than firmware V3.68H
Error number description string
Retrieving error buffer (last 8 appearing info’s, warnings or
errors)
Description of the error state from the SMU
(Only possible if SMU available)
Description of the error state of the SMU at the time of
error 89 (Only possible if SMU available)
To Next Page
Loading...
Need help?
General
