JXP680
Wiring
Power
JENSEN
Connect directly to the vehicle battery+
terminal with 8 gauge wire (minimum).
Fuse:
JXP680 50 AMP
Power Terminal (+lZV)
Remote Terminal (REM)
~~~+~
,$,,ze
Install as close
Terminal I
Terminal
Adapter
to the battery
/
as possible /
Ground Terminal (GND)
Connect to a good chassis ground. The ground
connection should be to clean, unpainted metal
to provide a good electrical connection.
GND REM +12”
Drill :/8” hole
in chassis
sheet metal
Connect the power antenna/amplifier turn-on
lead from the receiver to the AMPLIFIER
REMOTE terminal.
GND REM +12”
To Receiver
Power
Antenna Lead
Wire
Fuses
25A 25A
Use only blade-type fuses.
Fuse:
JXP680 2 X 25 AMP
5
To Next Page
Loading...
