Avoid installing the flame photometer in areas that are susceptible
to drafts, but ensure that there is adequate ventilation to prevent
any build
Before using any cleaning or decontamination methods except those
specified by the manufacturer,
should check
with the manufacturer that the proposed method will not damage
the equipment.
In order to completely disconnect power to the flame photometer
the mains power cord must be d
etached from the back of the unit.
Ensure a suitably rated detachable mains cord is used.
This hazard symbol is present on the flame chimney outer casing and
indicates that the surface may be hot to touch.
To Next Page
Loading...
