and so we cannot guarantee that interference will not
occur in practice. Where there is a possibility that injury,
damage or loss might occur if equipment malfunctions
due to radio frequency interference, or for general
advice before use, contact the manufacturer.
This product meets the applicable EC
harmonised standards for radio frequency
interference and may be expected not to
equipment used in its vicinity will meet these standards
Declaration of Conformity is also available to view online at www.jenway.com
interfere with, or be affected by, other equipment with
VLPLODU TXDOLœFDWLRQV :H FDQQRW EH VXUH WKDW RWKHU
EU Declaration of Conformity
This declaration of conformity is issued under the sole responsibility of the manufacturer
Signed for and on behal
f of the above manufacturer
Product Laboratory Equipment
Manufactur
er Cole-Parmer Ltd
Beacon Road
Stone, Staffordshire
ST15 0SA
United Kingdom
File Number P225
Authorised Cole-Parmer
Repr
esentative Beacon Road
Stone, Staffordshire
ST15 0SA
United Kingdom
Object of Declaration
The object of the declaration described above is in conformity with the relevant Union Harmonisation Legislation:
Additional Information
Place of Issue
Date of Issue
Authorised Repr
esentative
Title
Signature
References to the relevant harmonised standards used or referen
to which conformity is declared:
IEC/EN 61010-1:2001
Safety requirements for electrical equipment for
measurement, control and laboratory use.
Part 1: General requirements.
Particular requirements for laboratory equipment for the
heating of materials.
IEC/EN 61010-2-010:2003
Low Voltage Directive
EMC Directive
RoHS Directive
2011/65/EC
Year of CE Marking: 1996
Stone, Staffordshire, UK
October 2009
Carl Warren
Technical Manager
Flame Photometer Range
(reference the attached list of catalogue numbers)
Electrical equipment for measurement, control and
laboratory use. EMC requirements.
Part 1: General requirements (Class A).
IEC/EN 61326-1:2006
To Next Page
Loading...
