To Next PageTo Next PageWhat causes wood to be gouged when using Jet 16-32 Plus Sander?
Wood gouging when using the Jet Sander can occur if the stock is slipping on the conveyor or if the workpiece is not properly supported. Correct the depth of cut or roller tension to prevent stock slippage, and add work supports for long workpieces.
General| Maximum Board Width | 32" |
|---|---|
| Dust Port Diameter | 4" |
| Feed Rate | 0-10 FPM |
| Voltage | 115V |
| Sanding Capacity (Thickness) | 3 inches |
| Abrasive Width | 16 inches |
| Drum Speed | 1725 RPM |
Covers warranty scope, coverage period, and exclusions.
Procedure for obtaining service and required documentation.
Explains warranty limitations and state law applicability.
Essential safety rules before assembly or operation.
Rules for safe operation, maintenance, and workshop environment.
Explains the meaning of CAUTION and WARNING notices.
Labeled diagram of the drum sander's main parts.
Lists parts included in Box #1 and Box #2.
Instructions for attaching optional locking casters.
Steps to mount the drum head assembly to the stand.
Procedure to attach the conveyor bed and motor.
How to prepare and attach abrasive strips to the drum.
Guide on using the TUFTool for abrasive tensioning.
How to adjust the drum height and depth of cut.
Procedure for preventing unauthorized machine start-up.
How to calibrate the depth gauge indicator.
Adjusting conveyor belt tension and tracking.
Steps for replacing a worn conveyor belt.
Covers circuit breaker, basic procedures, depth of cut, and drum height.
Tips for maximum performance and operational dust collection.
Covers multiple pieces, edges, imperfect stock, feeding angle, and cleaning.
Addresses sander not starting and conveyor problems.
Solutions for abrasive strip problems and sanding quality defects.
Addresses wood burning and surface imperfections.
Fixes for height adjustment, overload, and wiring problems.
Guidance on choosing, cleaning, and maintaining abrasives.
