18
Maintenance
Before performing any
maintenance on the machine, disconnect it
from the electrical supply by pulling out the
plug or switching off the main switch.
Failure to comply may cause serious injury.
Keep the table surfaces clean and free of rust. If
rust appears on the tables, use 000 steel wool
with a paste mixture of household ammonia and
good commercial detergent (or use a
commercial rust remover available from most
hardware stores.)
A light coat of paste wax on the tables will help
protect them from tarnish and reduce friction
between table and workpiece.
Note: Do not get paste wax on the abrasive belt
or disc.
Check all fasteners for tightness.
Inspect the power cord; if worn, cut, or damaged
in any way, have it replaced immediately.
Inspect the abrasive belt and disc. If either is
worn, replace it.
Occasionally remove the belt cover and brush
out any shavings or debris from around the
wheels.
Lubrication
All of the ball bearings are packed with grease
and sealed at the factory. They require no
further lubrication.
Replacement Parts
To order parts or reach our service department, call 1-800-274-6848, Monday through Friday (see our
website for business hours: waltermeier.com). Having the Model Number and Serial Number of your
machine available when you call will allow us to serve you quickly and accurately.
To Next Page
Loading...
Need help?
General
