8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the sander is
assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Belt and Disc Sander
1 Belt Table
1 Disc Table with trunnions
1 Miter Gauge
1 Dust Chute
6 Phillips Pan Hd. Machine Screws, 3/16x3/8”
3 Handles
3 Flat Washers, 3/8”
1 Tension Handle
1 Hex Nut, 1/4”
3 Hex Wrenches, 3, 4 and 6mm
1 Owner's Manual
1 Warranty Card
Read and understand the entire contents of this manual before attempting set-up
or operation! Failure to comply may cause serious injury.
To Next Page
Loading...
Need help?
General
