Table of Contents Page
Warranty..................................................................................................................................................2
Warnings.................................................................................................................................................3
Table of Contents.....................................................................................................................................4
Specifications...........................................................................................................................................4
Unpacking and Clean-Up.........................................................................................................................5
Spindle & Insert Holders...........................................................................................................................5
Installing Spindles....................................................................................................................................5
Insert Plates ............................................................................................................................................5
Setup for 90° ...........................................................................................................................................6
Setup for Bevel Sanding ..........................................................................................................................6
Dust Collection ........................................................................................................................................6
Turning the Sander On & Off....................................................................................................................6
Removing Spindles..................................................................................................................................7
Changing Sanding Sleeves......................................................................................................................7
Replacement Sanding Sleeves ................................................................................................................7
Parts Breakdown ..................................................................................................................................8-9
Parts List ..........................................................................................................................................10-12
Specifications
JBOS-5.......................................................................................................................................... 708404
Table Size (in)....................................................................................................................14-1/2”x14-1/2”
Table Tilt (down)................................................................................................................................ 0-45°
Spindle Speed (rpm) .........................................................................................................................1,725
Oscillations (per minute) ........................................................................................................................30
Length of Oscillations (in).........................................................................................................................1
Motor (TEFC).................................................................................................................1/2 HP,1Ph,110V
Net Weight (lbs).....................................................................................................................................77
The specifications in this manual are given as general information and are not binding. JET Equipment
& Tools reserves the right to effect, at any time and without prior notice, changes or alterations to parts,
fittings, and accessory equipment deemed necessary for any reason whatsoever.
To Next Page
Loading...
Need help?
General
