To Next Page

To Previous Page

Introduction

This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures

for a JET Model JFM-5 Mortiser. This manual contains instructions on installation, safety precautions,

general operating procedures, maintenance instructions and parts breakdown. This machine has been

designed and constructed to provide years of trouble free operation if used in accordance with

instructions set forth in this manual. If there are any questions or comments, please contact either your

local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site:

www.wmhtoolgroup.com.

Specifications

Model Number.................................................................................................................................JFM-5

Stock Number..............................................................................................................................708589K

Spindle Speed (RPM) ........................................................................................................................1725

Chisel Capacity (in.).......................................................................................................................1/4 to 1

Chisel Shank Capacity (in.).................................................................................................. 5/8, 3/4, 1-1/8

Maximum Chisel Stroke (in.)....................................................................................................................8

Chuck Capacity (in.)..............................................................................................................................1/2

Bushing Size (dia./in.).......................................................................................................... 5/8, 3/4, 1-1/8

Chisel Center to Fence Distance (in.).......................................................................................................4

Fence Size (in.) ......................................................................................................................... 3-1/2 x 20

Base Size (in.)............................................................................................................................... 14 x 16

Maximum Table Movement:

X-Axis (in.)........................................................................................................................................16

Y-Axis (in.)..........................................................................................................................................4

Motor................................................................................... TEFC, 1HP, 1Ph, 115/230V (pre-wired 115V)

Overall Height on Base (in.)...................................................................................................................61

Shipping Weight (lbs.)....................................................................................................................... 290.2

Net Weight (lbs.)............................................................................................................................... 267.3

The above specifications were current at the time this manual was published, but because of our policy of

continuous improvement, WMH Tool Group reserves the right to change specifications at any time and

without prior notice, without incurring obligations.