10
Assembly
For assembly convenience, the item letter
designators used throughout the Assembly section
are the same as those used to identify shipping
content and hardware components on pages 8–9.
Stand Assembly
Note: If you do not plan to use a standat this time,
skip this page and proceed to Jointer-Planer
Assembly on the following page.
Referring to Figure 7:
1. Select two legs (S
E
), one short stand top
support (S
D
) and one short support plate (S
B
).
2. Attach one end of the stand top support (S
D
) to
the top of the first leg with two carriage bolts
(S
G
), flat washers (S
H
), lock washers (S
J
) and
hex nuts (S
K
). Attach the other end of the
stand top support (S
D
) to the second leg in the
same manner. Hand-tighten only at this time.
3. Attach a support plate (S
B
) to each leg (S
E
) in
the same manner with two carriage bolts (S
G
),
flat washers (S
H
), lock washers (S
J
) and hex
nuts (S
K
). Hand-tighten only at this time.
4. Repeat steps 1–3 using the remaining legs,
short stand top support and support plate.
5. Complete the stand construction by attaching
long stand top supports (S
E
) and long support
plates (S
A
) to the leg assemblies constructed
in steps 1–4. Hand-tighten all hardware only at
this time.
6. Place a rubber foot (S
Q
) on a hex cap screw
(S
F
), then insert the threaded end of the screw
through the opening on the bottom of the leg.
7. Secure with flat washer (S
H
) and hex nut (S
K
).
8. Attach rubber feet to remaining legs in the
same manner.
9. Place stand upright. Ensure that the stand is
on a level surface and all four legs are
contacting the surface.
10. Tighten all hex nuts with the 10mm
wrench (U, Fig. 4) provided.
Mounting Jointer-Planer to Stand
Referring to Figure 8:
1. Place the Jointer-Planer (D) onto the assembled
stand and secure with 4 socket head cap
screws (S
M
), lock washers (S
P
), and flat
washers (S
N
).
2. Tighten all socket head cap screws (S
M
) with
the 5mm hex wrench (W, Fig. 4) provided.
SK
SA
SB
SC
SD
SE
SK
SJ
SH
SK
SH
SJ
SG
SG
SH
SQ
SF
Figure 7
Figure 8
To Next Page
Loading...
