12
Troubleshooting
Trouble Probable Cause Remedy
Sander will not start.
Sander unplugged from wall or motor. Check all plug connections.
Fuse blown, or circuit breaker tripped
in service panel.
Replace fuse, or reset circuit breaker.
Cord damaged. Replace cord.
Starting capacitor bad. Replace starting capacitor.
Sanding drum does
not come up to
speed.
Extension cord too light or too long.
Replace with adequate size and
length cord.
Low current. Contact a qualified electrician.
Machine vibrates
excessively.
Stand or base on uneven surface.
Adjust stand or base so that it rests
evenly on the floor.
Sanded edge not
square.
Table not square to sanding drum.
Use a square to adjust table to
sanding drum.
Sanding marks on
wood.
Wrong grit sanding sleeve.
Use coarser grit for stock removal and
fine grit for finish sanding.
Feed pressure too great. Never force workpiece.
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848, Monday through Friday (see our website for business hours, www.waltermeier.com).
Having the Model Number and Serial Number of your machine available when you call will allow us to
serve you quickly and accurately.
To Next Page
Loading...
