To Next Page

To Previous Page

Introduction

The JET JWL-1442VS lathe you have purchased is a high quality tool that will give you years of superior

service. You will get maximum performance and enjoyment from your new lathe if you would take a few

moments now to review the entire manual before beginning assembly and operation.

The JET JWL-1442VS, as well as all JET products, is backed by a nationwide network of authorized

distributors and/or service centers. Please contact your nearest distributor should you require parts or

service. Parts are also available directly from JET by calling 1-800-274-6848.

Table of Contents

Warranty..................................................................................................................................................2

Warnings..............................................................................................................................................3-4

Grounding Instructions.............................................................................................................................5

115V Operation........................................................................................................................................5

230V Operation .......................................................................................................................................6

Introduction..............................................................................................................................................7

Table of Contents.....................................................................................................................................7

Specifications ..........................................................................................................................................8

Contents of the Shipping Container..........................................................................................................9

Unpacking and Cleanup...........................................................................................................................9

Assembly.................................................................................................................................................9

Stand Legs (optional accessory) ............................................................................................................10

Stand Shelf............................................................................................................................................10

Controls and Features ......................................................................................................................10-12

Lathe Tools.......................................................................................................................................12-13

Mounting Workpiece Between Centers...................................................................................................13

Stock Selection......................................................................................................................................14

Roughing Out ........................................................................................................................................14

Beads, Coves, “V” Cuts and Parting.......................................................................................................15

Sanding & Finishing...............................................................................................................................16

Face Plate or Bowl Turning....................................................................................................................16

Mounting Stock......................................................................................................................................16

Face Plate or Chuck ..............................................................................................................................17

Wood Selection......................................................................................................................................17

Checks and Cracks................................................................................................................................17

Distortion...............................................................................................................................................17

Tools for Bowl Turning............................................................................................................................17

To Shape Outside of Bowl......................................................................................................................18

To Shape Interior of Bowl.......................................................................................................................19

Sanding and Finishing ...........................................................................................................................19

Adjusting Clamping Mechanism.............................................................................................................20

Changing the Belt and Bearings.............................................................................................................20

Troubleshooting.....................................................................................................................................21

Part Breakdowns and Part’s List .......................................................................................................22-27

Wiring Diagram......................................................................................................................................28