Jetco Torque Tools ED SERIES - Page 13

Parameters
CR at end CR at end
12Jetco Torque Tools
Description
LIST OF ASCII COMMANDS
ExmapleCommand
DTC
ETC
Return calibration full scale torque Return current peak CW torque value Return current peak CCW torque value Enable Options Changes
RFS
CLP
ALP
ENB
Command: ENK,1,0,1,1<CR> Enables: Units Changes Target Changes Target Tolerance Changes Disables: Mode Changes Response: OK
Get: CR at end or ? CR at end Set: KEY,1,1,1,1 CR at end Position 1 = Units Change, 1 = Enabled, 0 = Disabled Position 2 = Mode Change Position 3 = Target Change Position 4 = Target Tolerance Change
Enable / Disable Keypresses. Stores setting in EEPROM
ENK
Command: RFS?<CR> or CLP<CR> Response: Calibration full scale torque in ASCII Command: CLP?<CR> or CLP<CR> Response: Current peak CW torque value Command: ALP?<CR> or ALP<CR> Response: Current peak CCW torque value Command: ENB<CR> Response: OK
Get: CR at end or ? CR at end Get: CR at end or ? CR at end Get: CR at end or ? CR at end CR at end
Disable target changes. Allows viewing only. Enable target changes.
Command: DTC <CR> Response: OK Command: ETC <CR> Response: OK
www.itorque.com