COMPLEX RADIO CONTROL SYSTEM
This setup is for transmitter modules only. For the DC/DS
transmitters, this alarm is set in the transmitter.
Output Period - output signal period setup (initial setup for the
Autosynchronizing mode with the transmitter). This parameter is
fundamentally influencing servo behaviour. With lower output
period values the reactions (response) of analog servos become
faster, but current consumption increases. With a too low setup
value some servos may even start chattering.
Serial Link - setup for receiver serial output mode:
JETIBOX - initial setup (except Rsat2 receivers); standard servo
signals are generated by the receiver outputs; JETIBOX output
available on Ext. port.
JETIBOX, PPM pos.- setup of the standard form of PPM signal
generation with positive logic at PPM outputs (see the table of
receiver output assignments). The bus idle state is log. 0.
JETIBOX, PPM neg.- setup of the standard form of PPM signal
generation with negative logic at PPM outputs (see the table of
receiver output assignments). The bus idle state is log.1.
The receiver may be set up in such a way that its output works in
digital communication form that will be used as input by other
equipment.
EX Bus - in this setup information about servo throws will be
generated in EX Bus protocol format. EX Bus protocol represents a
bidirectional digital communication, which transmits throw and
EN
18
To Next Page
Loading...
Need help?
General
