Operating Instructions
JETI spectroradiometer spectraval 15x1
Document Revision 105
6.5 Settings
For a better understanding of the possible settings some important terms and measure-
ment parameters are explained below. The different adjustment possibilities are divided
into Device Settings, Measurement Settings and View Settings.
6.5.1 Device Settings
6.5.1.1 Power Options
The Power Setting Options allows you to set different actions to take when the device is
left idle for a certain amount of time. If the device will turn off after a specific time, any
unsaved measurement data will be lost!
6.5.1.2 Touchscreen Calibration
Opens a window in which you can recalibrate the touchscreen (realign) should it react
imprecisely to touch.
6.5.2 Measurement Settings
6.5.2.1 Average
The Average setting can be used to obtain the spectrum as the mean value from up to
254 successive measurements.
6.5.2.2 Continuous Scan Interval
If you want to measure continuously, you can select the interval in the range of 0 s to
65 535 s. Note that you can begin a measurement session by tapping the Measurement
Button in the different Mode View and stop the session by pressing the Button again.
Copyright © 2017 JETI Technische Instrumente GmbH 25
To Next Page
Loading...
Need help?
General