Jeti spectraval 1501 User Manual

Operating Instructions
JETI spectroradiometer spectraval 15x1
Document Revision 105
5 Operation of Device
5.1 spectraval 15x1
The instrument will be switched on automatically shortly after it was connected to a PC
when the USB cable is used. This will be shown by the shining green LED.
Attention: The USB driver must be installed at first without connected instrument
(see chapter 3 ‘Drivers under Windows 7/ 8/ 10’, page 7).
If you communicate via Bluetooth, the device has to be switched on using the On/ off
switch on the rear side.
On/off switch and
on/off laser
Reset
Micro USB connector
Trigger input
Status LEDs
spectraval 1501
Measurement
button
Reset
Micro USB connector
On/off switch and
on/off laser
Display
Status LEDs
SD card slot
Trigger input
spectraval 1511
Remark: Connect the device to your PC to charge the battery via USB.
If spectraval is connected to PC via Bluetooth and the connection is interrupted,
spectraval is switched off immediately.
The battery status is shown by the yellow LED on the rear side of the device.
14 Copyright © 2017 JETI Technische Instrumente GmbH

Jeti spectraval 1501 Specifications

General

Brand	Jeti
Model	spectraval 1501
Category	Measuring Instruments
Language	English