4. TIGHTEN THE BOLT BY TURNING IT CLOCKWISE WITH THE ALLEN KEY. IF APPLICABLE, USE THE WRENCH TO HOLD THE
NUT STEADY.
IMPORTANT: WHEN ATTACHING THE FENDER, TAKE CARE NOT TO OVERTIGHTEN THE BOLT. OVERTIGHTENING CAN
CAUSE THE FENDER TO CRACK. ONCE YOU BEGIN TO FEEL RESISTANCE, TIGHTEN BY ½ ROTATION AT A TIME AND STOP
TIGHTENING WHEN THE FENDER FEELS SECURE IN PLACE.
5. CHECK THAT THE FENDER IS SECURE AND THE WHEEL SPINS FREELY UNDER THE FENDER.
10MM WRENCH
B
A
5MM
ALLEN KEY
4MM
ALLEN KEY
To Next Page
Loading...
