Jetson Bolt Pro - Securing the Rear Light; Securing the Bell; Mounting the Handlebar Bell

27
1.6 Securing the Bell
1. LOOSEN BUT DO NOT REMOVE THE SCREW ON THE BELL CLAMP BY TURNING IT COUNTERCLOCKWISE FOR 1  2
ROTATIONS WITH THE SCREWDRIVER.
2. ROTATE THE BELL AROUND THE HANDLEBAR UNTIL THE BELL TAB IS IN A PLACE THAT CAN EASILY BE REACHED BY THE
RIDER’S LEFTHAND THUMB WHILE HOLDING ONTO THE HANDLEBAR.
3. TIGHTEN THE SCREW BY TURNING IT CLOCKWISE WITH THE SCREWDRIVER.
BELL
SCREW
BELL TAB
PHILLIPSHEAD SCREWDRIVER TIP