2.2 Repositioning the Seat
WHEN A RIDER IS SEATED AND HAS A FOOT ON THE PEDAL AT THE LOWEST PEDAL ROTATION POINT, THERE SHOULD BE A
SMALL BEND IN THE KNEE. LEGS SHOULD NEVER BE FULLY EXTENDED DURING PEDALING. ADJUST SEAT HEIGHT ACCORD
INGLY TO ACHIEVE THIS POSITIONING.
IMPORTANT: NEVER RAISE THE SEAT SUCH THAT THAT THE “MINIMUM INSERTION” MARK ENGRAVED ON THE SEAT POST IS
VISIBLE ABOVE THE SEAT CLAMP.
TO RAISE OR LOWER THE SEAT:
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. RAISE OR LOWER THE SEAT TO THE DESIRED POSITION
WITHOUT EXPOSING THE “MINIMUM INSERTION”
MARK ABOVE THE CLAMP.
TROUBLESHOOTING: IF THE SEAT CLAMP IS TOO
TIGHT FOR THE POST TO SLIDE UP AND DOWN EASILY,
WIDEN THE CLAMP OPENING BY TURNING THE CLAMP
KNOB COUNTERCLOCKWISE.
3. HOLD THE SEAT IN PLACE AND CLOSE THE SEAT LATCH.
IF NECESSARY, TIGHTEN THE CLAMP BY TURNING THE
KNOB CLOCKWISE.
SEAT CLAMP
CLAMP LATCH
CLAMP KNOB
(opposite side-
not shown)
To Next Page
Loading...
