TO CHANGE YOUR CYLINDER LOCK CODE:
1. ROTATE EACH DIGIT AROUND THE CYLINDER UNTIL ALL 4 DIGITS IN THE
EXISTING CODE ARE ALIGNED IN THE CENTER FROM TOP TO BOTTOM.
“0000” IF STILL SET IN DEFAULT MODE
2. PUSH THE RESET SWITCH TO THE RIGHT.
3. ROTATE THE DIGITS UNTIL A NEW CODE IS DISPLAYED AND
ALIGNED IN THE CENTER.
4. PUSH THE RESET SWITCH TO THE LEFT TO PROGRAM YOUR NEW CODE.
IMPORTANT: THERE IS NO WAY TO RESET THE CODE OR USE THE LOCK
WITHOUT USING THE EXISTING CODE. BE SURE TO KEEP A NOTATION OF
YOUR CODE WHENEVER YOU CHANGE IT.
RESET SWITCH
To Next Page
Loading...
