22
press UP / DOWN keys on the microphone or press
“CHA+/CHA- or VOL+/VOL-”on the transceiver
front panel to select. Slots 10-15 can only be selected
by using the “UP/DOWN” buttons on the microphone
or “CHA+/CHA-“ or “VOL+/VOL-“ keys on the
transceiver front panel.
2, Manual transmission: If the DTMF autodial list is
empty, automatic DTMF transmission is disabled.
However, you can manually enter a sequence of
DTMF tones manually.
Press the “CALL” key twice, then enter your desired
sequence of DTMF tones from the keypad. Finally,
press the PTT key to transmit. You will hear the
DTMF tones transmit if they were properly entered.
Remote RX Inhibition and RXTX Inhibition
RX Inhibition: If RX Inhibit is enabled, the receiver
will remain inactive until it receives the correct RX
Enable code.
RXTX Inhibition: With RX/TX Inhibit enabled, the
transceiver will be unable to receive or transmit until it
receives the correct RX/TX Enable code.
Refer to page 46 for more about RX Inhibition and
RXTX Inhibition.
To Next Page
Loading...
