35
ROGER(ROGER): Menu 32
The transceiver can send a “Roger beep” to mark the
end of a transmission. Select Menu 32, and select
“ON” to enable this feature, or “OFF” to disable it.
The default setting is OFF.
REVERSE (REVERSE): Menu 33
The Reverse feature can only be enabled if Offset
Frequency and RPT Type, Menus 34 and 35, are also
set. The Reverse function swaps the receive and
transmit frequencies so that you can hear another
transceiver’s calls directly rather than through a
repeater. This would be useful in order to determine
whether you can establish direct contact with a nearby
station, freeing up the repeater for other uses.
To set the Reverse function, set Menu 33 to “ON”. To
return to normal operation, set Menu 33 to “OFF”.
Offset Frequency (RPT SET/RPT TYPE): Menus
34 and 35
You can set a channel to use different receive and
transmit frequencies. This is most useful for operating
through a repeater, which receives on one frequency
and then retransmits on another frequency from a
higher antenna. This effectively provides systems
To Next Page
Loading...