38
Note: Press any key except “UP”, “DOWN”, “CHA+/CHA-“,
or “VOL+/VOL-“ to stop scanning.
Scan Type: You may choose two different scanning
modes:
VFO frequency scan: All frequencies on the band
will be scanned.
In VFO mode, select Menu 37 and press M key
to start scanning. The scan will begin at the
current frequency and continue up the band. To
reverse the scan direction, press the “DOWN”
key, the “CHA- “key, or the “VOL-“ key. Scan up
the band again by using the “UP” key, the
“VOL+” key, or the “CHA+” key. Press any other
key to stop scanning.
MR/CH scan: Scan only programmed memory
channels in this mode. From MR/CH mode,
select Menu 37, and press the “M” key to start
the scan. Scanning begins on the current channel
and scans up to higher channel numbers. To
reverse the scan direction, press the “DOWN”
key, the “CHA-” key, or the “VOL-“ key. Scan up
the band again by using the “UP” key, the
“VOL+” key, or the “CHA+” key. Press any other
key to stop scanning.
Note:
1. Each memory channel can be set to be blocked
from scan through Menu 39. If Scan Add is
To Next Page
Loading...
