The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device Power-up Delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item: ‘Device Power-up
Delay in Seconds’.
Device Power-up Delay in Seconds
The delay range is from [1] to [40] seconds, in one second increments.
Mass Storage Devices:
Generic Flash Disk XX
This is for user to set emulation type for current available mass storage device.
The optional settings are: [Auto]; [Floppy]; [Forced FDD]; [Hard disk]; [CD-ROM].
‘Auto’ enumerates devices according to their media format. Optical drives are
emulates as ‘CDROM’. Driver with no media will be emulated according to driver
type.
Platform Trust Technology
Press [Enter] to make settings to make further settings in ‘fTPM’.
TPM Configuration
fTPM
Use this item to enable or disable BIOS support for security device.
The optional settings are: [Disabled]; [Enabled].
Intel RMT Configuration
This item is for user to select Intel RMT (Ready Mode Technology) support.
Press [Enter] to make settings to make further settings in ‘fTPM’.
Intel RMT Configuration
Intel RMT Support
The optional settings are: [Disabled]; [Enabled].
To Next Page
Loading...
