What causes BMS fault code 05 - Overcurrent Charge in JLG Boom Lifts?
BMS fault code 05, "Overcurrent Charge," in JLG Boom Lifts can occur if the lithium pack is warm, one cell is at the maximum voltage, and the battery charger is suddenly connected, causing a current impulse to be supplied to the pack.
General| Power Source | Diesel |
|---|---|
| Jib Length | 6 ft |
| Overall Width | 8 ft |
| Gradeability - 2WD | 45% |
| Engine Type | Diesel |
| Engine Power | 74 hp |
| Fuel Type | Diesel |
| Platform Length | 6 ft |
| Platform Size | 30 x 72 in |
| Ground Clearance | 1 ft |
| Platform Width | 2.5 ft |
Essential safety guidelines for operating and maintaining the equipment.
Procedure for activating the electric motor in emergency situations.
Overview of fault code display and general troubleshooting approach.
List and description of BMS fault codes for different generations.
List and description of inverter fault codes and corrective actions.
Fault codes and solutions for battery chargers.
To Next Page
