vision
Snack Plus/Easy Combo
//
Vending
MNP86V03GBV00 Date: 2010/06/14 Rev. 0 PAGE 21 OF 62
A. T-15 validator
B. Coin separator
C. Display and pushbuttons
D. U-shaped plate
E. Photocells
F. Return motor
G. Change tubes
H. Vault acceptance channel
I. Recovery channel
J. Return carriage
K. Safety stops
Fig. 34
4.12.1. Coin separator
It sends the coins accepted by the coin selector to one of the five tubes or to the vault,
through the vault acceptance channel. The photocell assembly at the bottom of the coin
separator allows for quick coin location and detection of possible jams (see fig. 34).
4.12.2. Return carriage
This is the system that extracts the coins from each of the five return tubes with the help
of catches. There are also two stops that prevent coins from accidentally dropping from
the tubes (see fig. 34).
4.13. Recovery motor
Fig.35
This is the component that allows the machine
to recover a coin from the selector.
It is screwed and clipped onto a the coin guide
in the product delivery bin. It works on a 12
VDC supply through a wire connected to the
control card.
To Next Page
Loading...
