46
10 MH 320 PRO BEAD ASSIST
ATTACHMENT
(IF FIELD RETROFITTING NON EQUIPPED
UNITS)
10.1 INTRODUCTION
The model MH 320 PRO Bead Assist Attachment is
intended to be used to ease the mounting and de-
mounting of car tires.
The BEAD ASSIST can be used only in conjunction
with John Bean EHP Series Tire Changers.
The MH 320 PRO should be used only as intended
and instructed so within its manual.
Any other use shall be considered as improper and
not reasonable.
In particular, the installation on machines not allowed
can result in hazardous conditions.
The manufacturer shall not be considered liable for dam-
ages caused by improper, wrong or, unreasonable use.
Read carefully all warnings and instructions of its man-
ual since they provide important information concerning
the safety and maintenance of the MH device.
10.2 GENERAL SAFETY INSTRUCTIONS
Operation of this device should be restricted to only personnel
who are properly trained.
Any deviation or modi! cation of this device or of its parts or
components not previously authorized by the manufacturer
waive the manufacturer from any damage consequent or
related to the above mentioned deviations.
Removing or modifying safety devices or warning labels of
the machine is in violation of safety regulations. The use of
this device is allowed only in locations with no explosion or
! re hazard.
Only original accessories are to be used in conjunction with
this device. Any repair or routine maintenance items should
include only original spare parts and accessories.
The installation should be performed by quali! ed personnel
and within respect of the instructions provided for within its
manual.
The raise-descent speed of the movable column is limited
to 0.2 m/sec to prevent compression hazards.
The lower bead-push device is free to rotate around the
horizontal and vertical axis to prevent entrapping and com-
pression hazards against the self-centering chuck of the
machine on which the device is being mounted.
To Next Page
Loading...
