8
INSTRUCTIONS: Safety Label Meanings
IMPORTANT!! SAVE THESE INSTRUCTIONS
Overin• ated tires or tires mounted on the wrong sized rims can explode producing hazardous • ying debris.
• Read and understand the operation instructions before using this tire changer.
• Never mount tire on rim with different sized diameter.
• Never exceed maximum in" ation pressure listed on tire sidewall.
• Always use safety restraint arm to hold wheel in place while in" ating.
• Always use attached air hose to in" ate tires.
Exploding tires can cause death or serious injury.
Risk of electrical shock.
• Do not operate equipment with a damaged power cord or if the equipment has been dropped or damaged,
until it has been examined by a quali# ed service person.
• If an extension cord is necessary, a cord with a current rating equal to or greater than that of the equipment
should be used. Cords rated for less current than the equipment can overheat.
• Unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from the outlet.
Grasp plug and pull to disconnect.
• Do not expose the equipment to rain. Do not use on wet surfaces.
• Plug unit into correct power supply.
• Do not remove or bypass grounding pin.
Contact with high voltages can cause death or serious injury.
Risk of electrical shock. High voltages are present within the unit.
• There are no user serviceable items within the unit.
• Service on the unit must be performed by quali# ed personnel.
• Do not open any part of the unit other than noted and allowed areas.
• Turn power switch off and unplug the unit before servicing.
Contact with high voltages can cause death or serious injury.
Risk of crushing.
• Become familiar with all controls before proceeding with operation.
• Stand away from the bead breaker arm when in operation.
• Apply air to breaker in bursts if necessary to control arm depth.
• Don’t allow to approach extraneous people to the service.
Contact with moving parts could cause injury.
Risk of pinching or crushing hands and ! ngers.
• Keep hands and # ngers clear of rim edge during demounting and mounting process.
• Keep hands and # ngers clear of mount/demount head during operation.
• Keep hands and other body parts away from moving surfaces.
• Do not use tools other than those supplied with tire changer.
• Do not use unapproved accessories
• Do not bypass any safety features.
• Use proper tire lubricant to prevent tire binding.
Contact with moving parts could cause injury.
Risk of eye injury. Debris, dirt, and • uids may drop from wheels.
• Remove any debris from tire tread and wheel surfaces.
• Remove excess tire lubricant before in" ating.
• Knock off any loose debris. Clean surfaces as needed to avoid any materials from falling.
• Wear approved safety glasses during mount and demount procedures.
Debris, dirt, and • uids projection can cause serious eye injury.
Risk of injury. Tools may break or slip if improperly used or maintained.
• Use the correct tool for the task.
• Frequently inspect, clean, and lubricate (if recommended) all tools.
• Follow recommended procedures when performing wheel services.
Tools that break or slip can cause injury.
Collision and dragging hazard:
• do not rotate the turntable without wheel on board
• do not approach the turntable plate while it is moving
• pay attention to the jaws when these stick out of the turntable plate
• do not place any protruding objects on the turntable plate
• do not place any protruding objects near the turntable plate
Contact with moving parts could cause injury.
To Next Page
Loading...
