S
pecifications
Power Supply
Requirements
Single phase 230 Vac ±10%
Three phase 400 Vac ±10%
Not all power supplies are available in every
version. Please refer to selection tables.
Frequency
50/60 Hz
Protection Class
IP 65
Insulation
Class 2 when digital input switch and wire have a dielectric of 1300 Volts
Ambient Operating
Conditions
0° to +40°C (32° to 104°F)
0 to 100 % RH (when properly closed)
Ambient Storage
Conditions
-30° to +80°C (-22° to +176°F)
0 to 95 % RH (non condensing)
Control range
-40 to +70°C
Accuracy
± 1°C
Sensor cables
2 meters
Compressor
See selection table
Defrost
See selection table
Fan
See selection table
Door Frame Heater
Pump down
0,1 Amps 230 V ac
Alarm
0,5 Amps 230 V ac
Output ratings
Heater
1 Amps 230 V ac
Dimensions (H x W x D)
12 Modules
18 Modules
24 Modules
36 Modules
275 x 220 x 140
380 x 220 x 140
275 x 370 x 140
380 x 370 x 140
Directives
EN 60439-1 Tested Type Appliance (TTA)
The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond
these specifications, consult the local Johnson Controls office or representative. Johnson Controls shall not be liable for damages
resulting from misapplication or misuse of its products. This document is subject to change without prior notice.
Johnson Controls International, Inc.
Headquarters: Milwaukee, WI, USA
European Headquarters: Westendhof 8, 45143 Essen, Germany
European Factories: Lomagna (Italy), Leeuwarden (The Netherlands) and Essen (Germany)
Branch Offices: Principal European Cities.
This document is subject to change Printed in Europe
16 CR1
Catalogue Section 9 © 2000 Johnson Controls, Inc.
To Next Page
Loading...
Need help?
General
