Figure 24: Selecting the days
Figure 25: Setting the room occupancy mode
7. Select the Time Set button. See Figure 26.
8. Set the time to the time at which the event will occur and press Save. The screen resets to the
Event Set Schedule screen.
Figure 26: Selecting the time set button (left) and setting the event time (right)
9. Press Save to save the completed event or Trash to delete the completed event. See Figure 27.
The screen resets to the Event 1 Set Schedule screen.
Note: If you do not select Save at this point, the event is not saved and you must repeat the
event selection sequence.
37TEC3000 Series On/Off or Floating Fan Coil Thermostats Installation Guide