JOHNSON CONTROLS
3
FORM 160.69-N2
ISSUE DATE: 7/31/2015
MANUAL DESCRIPTION FORM NUMBER
Product Drawing 160.69-PA5.1
YD Unit Field Reassembly Instructions 160.69-NM3
Field Connections 160.69-PW1
Unit Wiring and Field Control Modications 160.69-PW2
YD Unit Installation Checklist and Request for Startup Engineer 160.69-CL1
YD with OptiView Control Center and EMS (Cooling Only) Operating Manual 160.69-O2
All Products - Service Policy 50.15-NM
CHANGEABILITY OF THIS DOCUMENT
In complying with Johnson Controls’ policy for con-
tinuous product improvement, the information con-
tained in this document is subject to change without
notice. Johnson Controls makes no commitment to
update or provide current information automatically
to the manual or product owner. Updated manuals, if
applicable, can be obtained by contacting the nearest
Johnson Controls Service office or accessing the John-
son Controls QuickLIT website at http://cgproducts.
johnsoncontrols.com.
It is the responsibility of rigging, lifting, and operating/
service personnel to verify the applicability of these
documents to the equipment. If there is any question
regarding the applicability of these documents, rig-
ging, lifting, and operating/service personnel should
verify whether the equipment has been modified and
if current literature is available from the owner of the
equipment prior to performing any work on the chiller.
CHANGE BARS
Revisions made to this document are indicated with a
line along the left or right hand column in the area the
revision was made. These revisions are to technical in-
formation and any other changes in spelling, grammar
or formatting are not included.
ASSOCIATED LITERATURE
To Next Page
Loading...
