WARNING
External wiring, unless specified as an optional connection in the manufacturer’s product line, is not
to be connected inside the control cabinet. Devices such as relays, switches, transducers and controls
and any external wiring must not be installed inside the micro panel. All wiring must be in accordance
with Johnson Controls’ published specifications and must be performed only by a qualified electrician.
Johnson Controls will not be responsible for damage or problems resulting from improper connections
to the controls or application of improper control signals. Failure to follow this warning will void the
manufacturer’s warranty and cause serious damage to property or personal injury.
Changeability of this document
In complying with Johnson Controls’ policy for continuous product improvement, the information
contained in this document is subject to change without notice. Johnson Controls makes no
commitment to update or provide current information automatically to the manual or product
owner. Updated manuals, if applicable, can be obtained by contacting the nearest Johnson
Controls Service office or accessing the Johnson Controls Solution Navigator website at https://
www.solutionnavigator.com/.
It is the responsibility of rigging, lifting, and operating or service personnel to verify the
applicability of these documents to the equipment. If there is any question regarding the
applicability of these documents, rigging, lifting, and operating or service personnel should verify
whether the equipment has been modified and if current literature is available from the owner of
the equipment before performing any work on the chiller.
Associated literature
Manual description Form number
Installation guide 160.75-N1.EN.CE
Operation and maintenance 160.75-O1.EN.CE
Nomenclature
Refer to YK Engineering Guide Form 160.75-EG1.EN.CE for shell, motor, and compressor combinations.
Model YK (Style G) Chiller Field Reassembly for Form 3 and Form 76
To Next Page
Loading...
