035-19569-101 (0109)
I-i
GB
Table of Contents
1 SUPPLIER INFORMATION 1-1
1.1 Introduction 1-1
1.2 Warranty 1-1
1.3 Safety 1-1
1.4 Responsibility for Safety 1-1
1.5 About this Manual 1-2
1.6 Misuse of Equipment 1-2
1.8 Safety Labels 1-3
1.9 Material Safety Data 1-4
2 PRODUCT DESCRIPTION 2-1
2.1 General 2-1
2.2 Capacity Control 2-2
2.3 Compressor 2-3
2.4 Compressor Lubrication System 2-3
2.6 Graphic Control Centre (OptiView) 2-5
2.7 Heat Exchangers 2-5
2.8 Refrigerant Flow Control 2-6
2.9 Options and Accessories 2-6
2.10 Nomenclature 2-7
2.11 Range of Models 2-8
3 TRANSPORTATION, RIGGING AND STORAGE 3-1
3.1 General 3-1
3.2 Shipment 3-1
3.3 Inspection, Damage and Shortage 3-2
3.4 Rigging 3-3
4 INSTALLATION 4-1
4.1 Location 4-1
4.2 Motors 4-1
4.3 Foundation 4-1
4.4 Clearances 4-1
4.5 Rigging Unit to Final Location 4-1
4.6 Locating and Installing Isolator Pads 4-1
4.7 Installing Optional Spring Isolators 4-2
4.8 Piping Connections 4-2
4.9 Evaporator and Condenser Water Piping 4-2
4.9.1 Chilled Water Circuit 4-5
4.9.2 Condenser Water Circuit 4-5
4.10 Stop Valves 4-6
4.11 Flow Switches 4-6
4.12 Drain and Vent Valves 4-6
4.13 Checking Piping Circuits and Venting Air 4-6
4.14 Refrigerant Relief Piping 4-6
4.15 Unit Piping 4-7
4.16 Control Panel Positioning 4-7
4.17 Control Wiring 4-7
4.18 Power Wiring 4-7
4.19 Units with Solid State Starter or
Variable Speed Drive 4-8
4.20 Thermal Insulation
4-8
4.21 Installation Check 4-8
5 COMMISSIONING 5-1
5.1 Preparation 5-1
5.2 First Time Start-up 5-2
To Next Page
Loading...
