MA1:15
V Range 502 l 652 l 802 Maintenance Manual
Johnston Sweepers Limited
Chapter - Scheduled Maintenance
90°- 75°
The spray angle should be maintained between 90 and 75 degrees to the panel
The nozzle distance should be greater than 1 metre minimum from the panel
1M
Alternative Methods
Clean with a sponge or soft cloth using cold or warm water with a soap or detergent,
followed by a cold water rinse
CLEANING THE VEHICLE
WARNING:
The use of safety goggles is recommended in case of deflected spray/debris.
NEVER direct a high pressure nozzle at the skin as the fluid may penetrate the
underlying tissue etc. and cause serious injury.
NOTICE:
Care MUST be taken not to damage sign written areas when cleaning.
See special notes for cleaning vehicles with vinyl livery below.
ALWAYS keep pressure equipment in good condition and regularly maintained,
particularly at joints and unions.
Special notes for cleaning vehicles with vinyl livery or reflective markings
The Supawash handlance or similar can be used for cleaning areas of the vehicle
with vinyl or reflective markings subject to the following precautions being taken
The spray pattern should be a wide fan pattern
The nozzle pressure should be 80 bar (1000PSI) max
The water temperature should not exceed 60 ºC
Do not use acid or solvent cleaning solutions
To Next Page
Loading...
