Jonsered 2095 - Page 68

68
Lubricating system
6
A
B
B
C
Remove the oil pump.
Remove the oil pipe.
Dismantle the oil hose.
See chapter 8 ”Crankshaft and crankcase”
for the pump gear.
Remove the screw and clip which holds
the oil pump in position.
Bend carefully with a screwdriver and pull
out the oil pump from the pump housing.
Remove the oil pipe, first at the bar
attachment (note from which direction
the pipe goes into the the rubber seal)
and then at the pump housing.
Bend carefully with a screwdriver.
Release the oil hose from the pump hous-
ing by means of screwdriver and lift up the
hose from the oil tank.
See chapter 8 ”Crankshaft and crankcase”
for the pump gear.
Fitting, mod. 2054/2055
Clean all parts and inspect them for
damage and wear.
Pay attention to the following:
A. Check that the cogs are undamaged.
B. Check that the O-rings seal as in-
tended.
C. Replace the oil filter if it cannot be
satisfactorily cleaned.
D. Make sure that the oil passages are
free from impurities.
Lubricate them with oil.
Replace damaged parts.
Fit the oil pump in the reverse order to
dismantling.