Jonsered 2095 - Page 71

71
Lubricating system
6
Fit the lock screw and make sure that it
fits in the recess in the axle.
Lock the screw with Loctite AA or lock
paint.
Check that the pump can be rotated easily
and that it is easy to move axially.
Turn the pump gear so that the cam curve
comes to its highest position against the
control pin and fit the adjuster shaft.
Check that the sealing ring on the pressure
side is fitted, clean and undamaged.
Check that the O-ring is not damaged.
Fit a new one if so required.
Check that the sealing ring on the pressure
side is fitted, clean and undamaged.
Check that the O-ring is not damaged.
Fit a new one if so required.
Screw tight the pump gear and lock the
screw with Loctite or lock-paint.
Fit the adjuster shaft.