Jonsered CS 2240S - Guide Bar and Saw Chain Combinations; Saw Chain Filing and File Gauges; EC Declaration of Conformity

English – 31
TECHNICAL DATA
1155356-38 Rev.2 2014-12-02
Guide bar and saw chain combinations
The following cutting attachments are approved for the models Jonsered CS 2240 II and CS 2240S II.
Saw chain filing and file gauges
EC Declaration of Conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain
saws for forest service
Jonsered CS 2240 II, CS 2240S II from 2013’s serial numbers and onwards (the year is clearly
stated in plain text on the type plate with subsequent serial number), are in conformity with the requirements of the
COUNCIL’S DIRECTIVES:
- of May 17, 2006 ”relating to machinery” 2006/42/EC.
- of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.
- of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
For information relating to noise emissions, see the Technical data chapter. The following standards have been applied:
EN ISO 12100:2010, ISO 14982:2009, EN ISO 11681-1:2011.
Notified body: 0404, SMP Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has carried out EC
type examination in accordance with the machinery directive’s (2006/42/EC) article 12, point 3b. The certificates for EC
type examination in accordance with annex IX, have the numbers:
0404/09/2131 – CS 2240 II, CS 2240S II.
In addition, SMP, Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has certified conformity with
annex V of the Council’s Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC. The
certificates have the numbers:
01/161/079.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna April 8, 2013
Bengt Frögelius, Development director chainsaw R&D (Authorized representative for Husqvarna AB and responsible for
technical documentation.)
Guide bar Saw chain
Length, inch Pitch, inch Gauge, mm Max. nose radius Type
Length, drive links
(no.)
13
0,325 1,3 10T Jonsered H30
56
15 64
16 66
18 72