ANTI-VIBRATION SYSTEM
40 – English
WARNING!
The fuel used in the chainsaw has the
following hazardous properties:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
Anti-vibration system
!
Dismantling
1. Dismantle the following parts:
• Chain and bar. See the Operator Guide.
• Cylinder cover. See the Operator Guide.
• Tank unit. See page 38.
2. Remove the spring on the cylinder with a 4 mm Allen key.
See fig. 1.
3. Remove the springs on the tank unit with a 4 mm Allen key.
See fig. 2.
Cleaning and inspection
Clean and inspect all parts.
Assembly
1. Remove the springs on the cylinder with a 4 mm Allen
key. See fig. 1.
2. Assemble the following parts:
• Tank unit See page 39.
• Cylinder cover. See the Operator Guide.
• Chain and bar. See the Operator Guide.
Fig. 1
Fig. 2
Repair of thread inserts
Repair kits, 503 27 33-01, are available if the threads on
the chainsaw are worn.
First drill with:
6.1 mm drill to the magnesium crankcase.
Screw in the thread insert with a suitable bolt and key.
See fig.3.
Fig. 3
To Next Page
Loading...
