9. Assemble the wheel. See
To disassemble and
assemble the wheels on page 17
.
10. Fill the transmission oil tank until the oil is at the
maximum level. The product must be level and the
oil must have a temperature of approximately 20 °C.
11. Bleed the hydraulic system. See
To bleed the drive
system on page 30
.
12. Start the product and do a check for an oil leak from
the new shaft seals.
13. Do a check of the oil level and, if necessary, fill the
transmission oil tank after the test run.
8.5.11 To replace the hydrostat cable
8.5.11.1 To remove the hydrostatic transmission cable
1. Remove the frame tunnel cover. See
To remove the
covers on page 16
.
2. Loosen the cable locknut for the front hydrostatic
transmission ¼ turn and remove the locking spring.
3. Remove the cable clamp for the front hydrostatic
transmission that is attached below the tunnel cover.
4. Remove the transmission cover. See
To remove the
covers on page 16
.
5. Remove the locking spring and the ball joint on the
rear hydrostatic transmission cable from the arm.
Remove the rear clamp.
6. Lift off the front ball joint and pull out the cable.
7. Lift out the hydrostatic transmission cable and the
ball joint.
8. Loosen the two ball joints from the hydrostatic
transmission cable.
9. Pull out the hydrostatic transmission cable.
36 - Repair instructions 659 - 001 - 11.04.2018
To Next Page
Loading...
