English – 21
Maintenance schedule
The following is a list of maintenance procedures that must be performed on the Rider. For those points not
described in this manual, visit an authorised service workshop.
● = Described in this operator’s manual.
❍ = Not described in this operator’s manual.
WARNING!
No service operations may be performed on the engine or mowing deck unless:
• The engine has been stopped. • The parking brake is actuated.
• The ignition key has been removed. • The mowing deck is disengaged.
• The ignition cable has been removed from the spark plug.
MAINTENANCE
1)
First change after 5 hours. Replace after every 25 hours with heavy loads or high temperatures.
2)
Under dusty conditions cleaning and replacement should take place more frequently.
3)
With daily use, the Rider should be lubricated twice weekly.
4)
Performed by an authorised service workshop.
Check the engine oil level 39 ●
Check the engine’s cooling air intake 31 ●
Check the fuel pump’s air filter 28 ●
Check the steering wires 24 ●
Check the brakes 25 ●
Check the battery 28 ●
Check the safety system 29 ●
Check nuts and bolts – ❍
Check for any fuel or oil leakage – ❍
Clean around the silencer – ❍
Check the silencer 23 ●
Change the engine oil
1)
39 ●
1)
●
1)
Replace the air filter’s prefilter on FR 2116
2)
27 ●
Check the mowing deck 32 ●
Check the air pressure in the tyres (60 kPa/8.5 PSI) 31 ●
Lubricate the belt adjuster
3)
40 ●
Lubricate joints and shafts
3)
40 ●
Adjust the brakes FR 2111, FR 2111 M 25 ●
Check the V-belts – ❍
Check the transmission’s cooling fins on FR 2113, 2116 – ❍
Check the transmission’s oil level on FR 2113, 2116 40 ●
Adjust the parking brakes on FR 2113, 2116 25 ●
Inspecting and adjusting the throttle cable 26 ●
Clean the engine’s and transmission’s cooling fins
2,4)
– ❍
Replace the air filter’s prefilter and paper filter
2)
27 ●
Replace the fuel filter 26 ●
Replace the spark plug 28 ●
50
100
Page
Maintenance
interval hours
25
Maintenance
Daily
maintenance
before
starting
To Next Page
Loading...
