English – 31
Checking the tyres’ air pressure
The tyres’ air pressure should be 60 kPa
(0.6 kp/cm
2
/8.5 PSI) on all wheels.
In order to improve the drive power the pressure in
the rear tyres can be reduced to 40 kPa
(0.4 kp/cm
2
5.6 PSI).
The highest permitted pressure is 100 kPa
(1.0 kp/cm
2
/14 PSI).
IMPORTANT INFORMATION
Different air pressure in the front tyres will
result in the blades mowing the grass at
different heights.
MAINTENANCE
Checking the engine’s cooling air intake
FR 2111, FR 2111 M, FR 2113, FR 2116
Clean the air intake grille in the engine cover
behind the driver’s seat.
Fold up the engine cover.
Check that the engine cooling air intake is free of
leaves, grass and dirt.
Check the air duct, located on the inside of the
engine cover, ensure it is clean and does not rub
against the cooling air intake.
A clogged air duct or cooling air intake impairs the
cooling of the engine, which may result in engine
damage.
8009-262
8009-268
8009-412
8009-370
Main fuse
The fuse is located in a loose holder under the
battery case cover, in front of the battery.
Type: Flat-blade mounting, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse indicates that the mounting has burnt
off.
Pull the fuse out of the holder when replacing. The
fuse is used to pro ect the electrical system. If it
blows again shortly after replacing this is due to a
short circuit, which must be rectified before the
machine is used again.
WARNING!
The cooling air intake rotates
when the engine is running. Mind
your fingers.
Air intake grille
Cooling air intake
To Next Page
Loading...
