English – 43
8009-273
6008-240H
6008-232
LUBRICATION
Checking the oil level in the transmission
on FR 2113, FR 2115
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Check that there is oil in the transmission’s oil
tank. Fill if necessary with engine oil
SAE 10W/30 (class SF-CC).
Lubricating the belt adjuster
The belt adjuster should be lubricated regularly
using good quality molybdenum disulphide grease*.
1 nipple from the right-hand side under the engine’s
lower belt pulley, until grease is forced out.
With daily use, lubrication should be carried out
twice weekly.
General lubrication
All joints and bearings are lubricated using
molybdenum disulphide grease during manu-
facture. Continue to lubricate using the same type
of grease *. Lubricate the steering and control wires
using engine oil.
Carry out this lubrication regularly; with daily use,
the machine should be lubricated twice weekly.
* Grease from well-known brand names (petrol
companies, etc.) usually maintains a good quality.
The most important property is that the grease
provides good protection against corrosion.
To Next Page
Loading...
