lish
Driving
Driving the Rider
1 Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
2 For FR 2211 R and FR 2211 M
Disengage the engine and select the required gear.
The lock button on the gear shift lever must be held in to
engage reverse gear.
- Gears 1-4 are used for mowing
- Gears 4-5 are used for transporting
Starting can take place independent of which gear is
engaged.
3 For FR 2213 MA, FR 2216 A and FR 2216 A2
Carefully press down one of the pedals until the required
speed is obtained. Pedal (1) is used to drive forwards, and
pedal (2) to drive backwards.
4 Select the required cutting height (1-9) with the cutting
height lever.
It is important that the air pressure in both front wheels is
equal, 60 kPa / 0,6 bar / 8.5 PSI, to produce an even
cutting height.
5 Press in the lock button on the lifting lever and lower the
cutting unit.
Important Gear changes between forward gears must not
be made while the machine is moving.
The engine must be disengaged during each gear change.
Stop the machine before changing between forward and
reverse gears, otherwise this may result in damage to the
gearbox.
Never use force to engage a gear.
If a gear does not engage immediately, release the clutch
pedal and press it down again. Now try to engage the gear
again.
IMPORTANT INFORMATION
The life span of the drive belts is increased significantly if
the engine runs at a low speed when the blades are
engaged. Therefore apply full throttle first when the cutting
unit has been moved to the mowing position.
To Next Page
Loading...
